For Honda CBR400 NC29 Gullarm – pre 1993 bikes only. Stage 1 Dynojet kit provides increased power and improved throttle response over the whole rev range. Suits standard airbox, engine and exhaust. Adjustable to suit K&N air filter, race end can and full system.
The stage 1 kit is intended for motorcycles with a stock engine using the stock airbox, air filter and stock pipe. Stage 1 kits are fully adjustable to allow the use of a well designed aftermarket pipes and stock replacement air filters like K&N.Stage 1 kits are designed to improve throttle response and driveability and in most cases power increases of approximately 5% throughout the entire power range can be achieved.
*Warning – DO NOT FIT THIS KIT TO POST 1993 CBR400 NC29’s – YOU MUST CHECK THE CODE STAMPED ON THE SIDE OF THE CARBURETTORS PRIOR TO ORDERING THIS KIT. PLEASE CONTACT sales@rrp.direct for further information if you are in any doubt.
Product Code: DJH-1164
For Further Installation Instructions Please visit the Dynojet Website Here >
